Pulp and Paper Canada

News
AFT makes major contribution to UBC’s new LC refining research facility (December 01, 2010)


December 1, 2010
By Pulp & Paper Canada

A new low-consistency (LC) refiner system donated to the Pulp and Paper Centre at the University of British Columbia (UBC) was started up in August, marking another milestone in the University’s resea…

A new low-consistency (LC) refiner system donated to the Pulp and Paper Centre at the University of British Columbia (UBC) was started up in August, marking another milestone in the University’s research program to enhance paper quality and reduce energy consumption.

Advanced Fiber Technologies (AFT) contributed the key process equipment to enable UBC to expand its capabilities in LC refining –a technology that is now being exploited by the world’s leading papermakers to significantly improve the energy efficiency of mechanical pulp production, according to James Olson, a professor in the Mechanical Engineering Department at UBC and a member of the Advanced Papermaking Initiative.

Advertisment

“We are now starting up the most state-of-the-art, university- based LC refining facility in the world,” Olson says.

A member of the Aikawa Group, AFT designs and manufactures screening components and Finebar® refiner plates for the worldwide pulp and paper industry. To UBC, the company donated a 16-inch Aikawa AWW single-disc LC refiner plus Finebar refiner plates to process a full range of hardwood, softwood, and recycled fibers.

The Natural Sciences and Engineering Research Council of Canada (NSERC) provided funding to purchase ancillary equipment and West Fraser Mills in British Columbia donated a 150 HP motor to drive the refiner.

“AFT has consistently contributed to R&D to fully understand the science of screening,” says Dr. Robert Gooding, vice -president of technology at AFT. “This most recent contribution underscores our commitment to LC refining research.”

After a short “learning curve” to understand the complexities and nuances of the new facility, fundamental research and development will begin in earnest. The LC refining facility will allow UBC to test new ideas and concepts for pre-treatment, power reduction strategies, advanced controls, and the impact on paper surface qualities. “Of course, we will be eager to perform sponsored research for pulp product development to help the industry further improve its paper products,” Olson says.

Gooding adds that AFT will also utilize the facility for fundamental research on plate geometries and power-gap relationships, as well as supporting customer trials. Advanced Fiber Technologies, 819-562-4754, www.aikawagroup.com/html/aft.html


Print this page

Related



Leave a Reply

Your email address will not be published. Required fields are marked *

*