Toscotec to supply PM5 rebuild at Smurfit Kappa mill in France
January 11, 2019 – Toscotec has been awarded a contract by Smurfit Kappa Cellulose du Pin to rebuild the entire dryer section of its 6m wire PM5 at Facture, Aquitaine, France.
Toscotec will rebuild the entire pre-dryer section of the machine, including 36 new TT SteelDryers with a diameter of 1.8 m, maintaining the same machine length of the existing 43 cast iron cans.
The scope of supply includes four new TT Uniroll for the first battery. Toscotec will also rebuild the existing post-dryer section to improve the present design according to the new production rate, adding two new TT SteelDryers. The scope includes a rope-less tail threading system throughout the whole dryer section, an optimized tail transfer to the film press with a TT Ripper and TT Transfer (vacuum belt device), and an improved paper sheet transfer between press and dryer section.
The main auxiliary systems will also be part of Toscotec’s scope, including the lubrication system, the hood with its air and ventilation system and the sheet stabilization. The hall ventilation system will be also part of the package.
The PM5 produces white top kraft liner with a reel trim of 5,500 mm. Toscotec’s rebuild will allow the machine to increase speed up to approximately 900 m/min.
Cascades Packaging starts up PM1 after dryer rebuild by Toscotec
Smurfit Kappa achieves CO2 emissions reduction 3 years ahead of schedule
The supply includes engineering, erection, commissioning, start-up assistance and training.
Toscotec has been working with Smurfit Kappa for the past 10 years on several projects in Mexico, Colombia, Argentina, Italy and Austria.
"Thanks to the increased efficiency of the overall drying process, PM5 will significantly boost its capacity, and deliver actual energy savings, thereby cutting the mill’s energy bill," says Fabrizio Charrier, Toscotec’s area sales manager.
The project is scheduled for the first quarter of 2020.
BC projects employing pulp and paper residuals get $815K in fundingJuly 19, 2019 – Two projects that will use gene…
Ottawa funding two projects to improve bioplastics compostabilityJuly 18, 2019 – The federal government is handing out…
Viscose producer creates new fibre from FSC-certified dissolving pulpJuly 17, 2019 – Chinese viscose producer Tangshan Sanyou has…
Canfor Corporation's VP digital departs for CNJuly 18, 2019 – David Trent, Canfor Corporation's vice-president of…
TAPPI Introduction to Kraft Pulping and Bleaching Course
August 13-14, 2019
PAPTAC Atlantic Branch Conference
September 18-20, 2019
October 1-4, 2019
FPInnovations Pulp, Paper & Bioproducts Course
October 7-11, 2019
BLRBAC Fall 2019 Meeting
October 14-16, 2019
TAPPI PEERS 2019
October 27-30, 2019